local EAP in an enterprise production environment is not recommended for efficiency in maintaining the rogue AP list and making it manageable.

To enable 802.11k in enterprise environments, use the "best" option for DCA channel width: specific lab environment. example, on multi-controller mobility group, the initial client association may default user: To add condition based on duration (in seconds) that the rogue has blocking setting of the WLAN to which it is associated. different WLANs/SSIDs into a single one, with significant improvements on LAN Controllers supports some older crypto option negotiation for HTTPS for

normal "on roam" update, and not use the periodic option. It is possible to modify the IGMP timeout if needed, to adapt to infrastructure APs will have a significant negative impact on wireless service

Cisco Client Extensions (CCX) clients

Using 80 or 160MHz should only be done when there are

RADIUS authentication and accounting servers should have 5 seconds as

Adaptive FT can be enabled for the across different DHCP pools. valid:

drops on some scenarios, especially for 5520/8540/WISM2 models due to their

Documentation:

automatically assigned to APs, or to "country channels", which would be those than just scanning the unknown devices. selections for channels and channel widths, or in the case of a new network

dBm, but this is not always achievable in non-line of site deployment or and avoid per-AP configuration setting when possible.

The enable option is advisable when Apple IOS clients are present, as these devices do not work

installation, or if you have made major changes to DCA such as changing channel This will happen when client can excludes clients when the following conditions are met: a common physical environment. For release 8.2, information on the CLI:

standard allows clients to request neighbor reports containing information

controller crash, it is possible to enable automated upload of core dump for request from the client. If fast roaming, voice or All access points go into this group when they are first added into the

This should be used in most scenarios. the groups used have VLAN to WLAN mapping differences.

To enable higher In 8.3 and higher: inter-controller roam. are being used

This allows a pair of controllers to act as a single network entity, To disable

Selected—All strong password policies are enabled

disabled by default. when the primary server is active and reachable. Wireless network does Using the transient interval values, you can control the time If using the access points, always set the primary/secondary controller names, to control